If you see a reading in this range, you need to ventilate the area and immediately find the source of the CO. A reading of 0 to 50ppm is normal and safe, 50 to 100ppm isn’t dangerously high but should definitely be addressed. The display then shows the carbon monoxide level-a number between 0 and 999ppm (parts per million). Instead, there are four beeps followed by five seconds of silence before it repeats the pattern. However, it’s not like a fire alarm with a consistent beep going off repeatedly. ![]() The volume definitely gets your attention. Once we got the battery in and the unit installed, we tested the alarm. You can’t slap it up just anywhere, but we didn’t have a problem finding a location that met all the requirements. There are also instructions about the ideal height of installation (within three feet of the floor is best). For example, you should avoid the garage, anywhere near a window or vent, and any space within five feet of a heating or cooking appliance. The alarm comes with detailed instructions as to the appropriate locations. Even though installation isn’t difficult, you have to read through all the instructions before installing to make sure you’ve chosen a location that allows the alarm to work to its full potential. Installation: Choose your location with careĬarbon monoxide detectors can’t be installed just anywhere, and this one is no different. You’ll also have to make sure the alarm is within six feet of an electrical outlet because it still needs to be plugged in to operate correctly. If you choose to wall mount, you’ll need a screwdriver or drill. The alarm includes two mounting screws and anchors (for plasterboard or drywall). The third installation option-wall mounted-is slightly more labor intensive. Tabletop installation is even easier than direct plug-in you put the battery in, remove the adaptor and cord, plug in the alarm, and set it on the tabletop with the slide support extended. Sometimes, heavier plug-in devices pull the plug out of the outlet, but we didn’t have this issue so long as the slide was in place. The slide support-located on the back at the bottom-locks into several positions and needs to be used when the alarm is plugged directly into an outlet or used on a tabletop as it supports the alarm’s weight. You can even take out the adapter and rotate it so the alarm can be mounted on horizontal outlets. ![]() After going through the process ourselves, the direct plug-in and tabletop installations proved to be as simple as they come.įor direct plug-in, all you have to do is open the back, install the battery, and plug the alarm into an outlet. It offers three installation options: direct plug-in, wall mounted, and tabletop. We have to start with setup because that’s where the Nighthawk really shines. The Spruce / Stacey Nash Setup Process: Fast and easy
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |